How do I clear or unsync the 18R2 from my modules? (Er50)

You may want to unsync your 18R2 controller from firing modules if you reached the maximum addresses (ER50), or you want to organize the module address starting at A00. This FAQ document will go over the process for all firmware versions.

To unsync your modules from the 18R2 using firmware version 3.0 and lower, hold down the SYNC Button for 15 seconds. 

To unsync your modules from the 18R2 using firmware version 4.0, hold down the SYNC Button for thirty (30) seconds. 

To unsync your modules from the 18R2 using firmware version 5.0 and higher, hold down the CH- and CH+ buttons for 30 seconds.                     

The SYNC LED will flicker momentarily when unsynced. Re-start your remote and you can now begin to re-sync modules starting at address A00.

 

Was this article helpful?
12 out of 13 found this helpful

Comments

0 comments

Article is closed for comments.

Articles in this section

See more
Our Support Team Hours:
We can be reached by phone at 518-741-4300 or email help@cobrafiringsystems.com
Emergency Shoot Site Support
COBRA offers a 24-hour support system for on-site emergencies. If you are on a shoot site and encounter a show-stopping issue, please reach out to us via phone at 929-930-6868.