By default, the 6M operates on cues 1–6. However, you can configure the module to fire on 7–12 or 13–18 instead. For example, you could use three 6Ms on the same channel — one for cues 1–6, one for 7‑12, and one for 13–18. This setup allows you to fire all 18 cues from a single channel without needing to change channels between modules.
To change the cue range firing mode, press TEST and CH+ or TEST and CH− at the same time. The module will display 1, 7, or 13 to confirm which cue range it’s set to. Once configured, the module will remember your selection even if it’s powered off or the battery is removed.
The selected Cue Range Firing Mode will also display during the startup sequence.
Comments
Article is closed for comments.