How long does it take to arm the modules from the 18R2?

Arming a module using the 18R2 will take approximately half a second to two seconds per device. Anything longer than this may indicate weak signal strength and should be investigated. Once armed, the ARM LED should remain solid. If the ARM LED begins blinking after going solid, this indicates you may have a module with a weak signal. If this occurs, we recommend placing your 18R2 in TEST mode to check your signal values. For assistance in checking signal strength, please see the 18R2 controller User Guide Signal Strength support document.

 

Was this article helpful?
0 out of 1 found this helpful

Comments

0 comments

Article is closed for comments.

Articles in this section

See more
Our Support Team Hours:
We can be reached by phone at 518-741-4300 or email help@cobrafiringsystems.com
Emergency Shoot Site Support
COBRA offers a 24-hour support system for on-site emergencies. If you are on a shoot site and encounter a show-stopping issue, please reach out to us via phone at 929-930-6868.