Scott Smith
Articles
-
I did not add five seconds of silence to my audio track, is this an issue, and how do I add silence to the beginning of my script?
We recommend adding at least five seconds of silence to the beginning of a script; however, if you do not add silence, the script will still fire. Without adding the silence, you may hear a small b...
-
What gauge is the right angle adapter cable?
The right-angle DB25 cable is 24 AWG.
-
Do all modules use the same charger and charge port?
Yes, all modules use the same charger and charge port, 20V, and approximately 300mA of charge current.
-
Recharge Upgrade Kit Installation Guide
The COBRA 18M comes in two power configurations, the 9V battery, and a 14.8V internal rechargeable. If the module was purchased as a 9V module an upgrade can be performed to add the rechange and ex...
-
What is the number that appears when the TEST/ARM LED become solid?
When the TEST/ARM LED light is solid, the total number of devices that are on, and communicating with the 18R2 are displayed on the upper 7-segment display. All devices, including the 18M, 36M, ...
-
I already own a booster, can this be installed in to the Command Center?
Yes, you can install your existing booster into the Command Center. Please see the COBRA Command Center Installation Guide for assistance.
-
What information is shown on the bottom two 7-segment display?
The information shown on the bottom 7-segment display window includes: When the device is on, but not firing, the time interval between cues when executing an auto-fire sequence. If an error occ...
-
How do I pause and resume a script while running?
The ARM/PAUSE (some 18R2 Controllers only display ARM) button on the 18R2 will pause or resume the script while it is running. When you pause the script by pressing the ARM/PAUSE button, the 18R2 w...
-
What timing resolution does COBRA support, and does this vary across firmware and hardware versions?
Firmware versions 5.0.0 and higher support firing down to 1/100th of a second; 4.0.0 and lower is limited to 1/10th of a second firing resolution. 18M Hardware A does not support 1/100th of a sec...
-
What is the difference between a channel and address?
The channel is assigned to a module by the operator and can be any changed to any channel number you desire. An address is a unique identifier assigned by the 18R2 to each module and other devices ...