18M Startup Sequence

Firmware Version

The 18M displays the firmware version of the device first, such as “5.0.2.” All devices synced together must use the same firmware version.

To learn more about firmware versions and how to upgrade your system, please see Firmware Figured Out

Module Address

The module’s unique address. When first syncing an 18M to the controller, the module is automatically assigned a unique address, such as “A01” and “A02.” The 18R2 stores this address permanently for that module until it is synced to a different controller whereby the new 18R2 assigns a new address.

For more information on device addresses, see What is an address?

Voltage Mode

The firing module will display the voltage mode as 9.0, 12.0, 14.8, 18, or 24V. To change the voltage mode, press TEST and CH+ or TEST and CH- to move the voltage up or down.

For more information on the voltage mode, see What is voltage mode?
Note: Voltage mode will not display in firmware 3.0.1 or earlier.

1P Battery Life

The firing module shows the battery life range as 1P0, indicating no battery up to 1P9, indicating a fully charged battery. The battery compartment is located on the back of the module. The battery powers the system including, the RF module, LEDs and 7-segment displays and does not draw power from firing the cues.

For more information on the 18M battery life, see What is the battery life of the 18M?

Note: The 18M displays “Lo” if the module battery level is P3 or lower.

2P Battery Life

The firing module displays the battery life range as 2P0, indicating no battery up to 2P9, which means a fully charged battery. The battery compartment is located on the back of the controller and module. 2P batteries are only used to fire cues.

For more information on the 18M battery life, see What is the battery life of the 18M?

Note: The 18M displays “Lo” if the module battery level is P3 or lower.

Self-test

“tSt” displays as the firing module performs the following tests:
Cue responsiveness – Tests the responsiveness from each cue, ensuring each firing MOSFET turns on and off. If any cue is unresponsive, the system will display Er1 or Er2.

LED function – With the key in the TEST position only, the red and green LEDs will flash briefly.

Shorted/stuck button – During the self-test, if any button is pressed a false-positive to the shorted/stuck button test will occur, and error code Er3 will display.

For more information on 18M self-test error codes and how to resolve, see the Error Code Reference Guide.