I believe one of my modules has low signal strength; what do I do?

To test if your module is performing correctly, place the module about one meter off the ground using a milk crate, 5-gallon bucket, or something similar in size. Measure your signal from approximately 100 ft. away, and you should see a signal quality of about -45. In the event you are seeing a signal greater than -45, please reach out to COBRA support,  as additional testing will be requested to determine if there is a fault.

If you are running firmware version 5.0.2 or higher, make sure only one module is powered on during this test because the MESH network will give you inaccurate results otherwise.

Was this article helpful?
1 out of 1 found this helpful

Articles in this section

See more
Our Support Team Hours:
9:00am - 5:00pm EDT Monday to Friday. We can be reached by phone at 518-741-4300 or email help@cobrafiringsystems.com
Emergency Shoot Site Support
COBRA offers a 24-hour support system for on-site emergencies. If you are on a shoot site and encounter a show-stopping issue, please reach out to us via phone at 929-930-6868.